The Quick Start Guides provide simple step by step instructions on how to do an initial system setup for the AD-FMCADC7-EBZ boards on supported carriers.
Board | AD-FMCADC7-EBZ |
---|---|
ZC706 | v |
In most carriers, the AD-FMCADC7-EBZ board connects to the HPC connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. The Zynq carriers program the FPGA and boots Linux from the SD card. The fabric only carriers use XMD to program the FPGA and download the Linux image. Please follow the specific switch settings for Linux or JTAG (no-OS) mode of your carrier of choice.
All you need to do is build SD card or download the SD card image of the latest releases. The instructions are here.
声明:本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人,不代表电子发烧友网立场。文章及其配图仅供工程师学习之用,如有内容侵权或者其他违规问题,请联系本站处理。 举报投诉
全部0条评论
快来发表一下你的评论吧 !