The ability to measure Neutral Currents is a key feature to enable the user to enhance tamper detection techniques. The current demo board firmware has the capability to measure Neutral Currents using the Compute Engine (CE) Firmware. All that is required is a minor modification to the existing demo board and firmware, which will be discussed below.
To measure Neutral Currents, a 4th current input channel needs to be created to be used along with the existing three voltage and three current inputs (VA, VB, VC, IA, IB, IC). The Neutral Current measurement can be implemented using the existing 71M6513 demo board with minor hardware and firmware modifications as given below:
Hardware Modifications:
a. The Neutral Current input can be connected to the 71M6513 Auxiliary input V3 (pin 86)
b. Analog Auxiliary input V3 is measured with respect to VBIAS (pin 81)
c. The input circuit for Neutral Current measurement is to be added as shown in the figure below:
声明:本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人,不代表电子发烧友网立场。文章及其配图仅供工程师学习之用,如有内容侵权或者其他违规问题,请联系本站处理。 举报投诉
全部0条评论
快来发表一下你的评论吧 !