The LM48511 integrates a boost converter with a high efficiency
Class D audio power amplifier to provide 3W continuous
power into an 8Ω speaker when operating from a 5V
power supply. When operating from a 3V to 4V power supply,
the LM48511 can be configured to drive 1 to 2.5W into an
8Ω load with less than 1% distortion (THD+N). The Class D
amplifier features a low noise PWM architecture that eliminates
the output filter, reducing external component count,
board area consumption, system cost, and simplifying design.
A selectable spread spectrum modulation scheme suppresses
RF emissions, further reducing the need for output filters.
The LM48511’s switching regulator is a current-mode boost
converter operating at a fixed frequency of 1MHz. Two selectable
feedback networks allow the LM48511 regulator to
dynamically switch between two different output voltages, improving
efficiency by optimizing the amplifier’s supply voltage
based on battery voltage and output power requirements.
声明:本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人,不代表电子发烧友网立场。文章及其配图仅供工程师学习之用,如有内容侵权或者其他违规问题,请联系本站处理。 举报投诉
全部0条评论
快来发表一下你的评论吧 !