资料下载
adxl363微传感器包括加速度和温度数据表
分享资料个
The ADXL363 is an ultralow power， three-sensor combination consisting of a 3-axis MEMS accelerometer， a temperature sensor， and an on-board ADC input for synchronous conversion of an external signal. The entire system consumes less than 2 µA at a 100 Hz output data rate and 270 nA when in motion triggered wake-up mode. The ADXL363 communicates via a serial port interface （SPI） and always provides 12-bit output resolution for all three sensors. The ADXL363 accelerometer provides selectable measurement ranges of ±2 g， ±4 g， and ±8 g， with a resolution of 1 mg/LSB on the ±2 g range. Unlike accelerometers that use power duty cycling to achieve low power consumption， the ADXL363 does not alias input signals by undersampling; it samples the full bandwidth of the sensor at all data rates. The ADXL363 temperature sensor operates with a scale factor of 0.065°C （typical）。 Acceleration and temperature data can be stored in a 512-sample multimode FIFO buffer， allowing up to 13 sec of data to be stored. In addition to the accelerometer and temperature sensor， the ADXL363 also provides access to an internal ADC for synchronous conversion of an additional analog input. The ADXL363 operates on a wide 1.6 V to 3.5 V supply range， and can interface， if necessary， to a host operating on a separate， lower supply voltage. The ADXL363 is available in a 3 mm × 3.25 mm × 1.06 mm package.
声明：本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人，不代表电子发烧友网立场。文章及其配图仅供工程师学习之用，如有内容侵权或者其他违规问题，请联系本站处理。 举报投诉
- 相关下载
- 相关文章
