请问ESG-D3000A是否适用于82357B USB/GPIB接口？

嗨 - 我自己没有机会在ESG-D3000A（E4432A）校准软件上尝试这个，因为它是一个过时的型号 - 甚至在82357B USB / GPIB接口开发之前。
但是，这已经在ESG-B模型校准软件上进行了尝试，并且它可以工作。
问候 -



     以下为原文

  Hi -

I did not get a chance to try this out on the ESG-D3000A (E4432A) calibration software myself since it’s an obsoleted model - even before the 82357B USB/GPIB interface was developed.  

But, this has been tried on the ESG-B model calibration software, and it works.  

Regards -

嗨Talbot，对不起延迟回复，它现在有效。
与在后台运行的另一个I / O软件发生冲突。
谢谢！



     以下为原文

  Hi Tabbott,
Sorry for delayed responce, it works now. Was conflict with another I/O software running in the background.
Thanks!

我很高兴听到该软件适合您。
如果您不将地址从GPIB0更改为HPIB7，则通常会出现该错误。
该软件通常需要看到HPIB7转到Agilent I / O连接专家并将SICL接口ID更改为HPIB7，您无法滚动到它，但只要输入错误就可以输入它。
我希望这有帮助。
Joe Lubecky测试设备



     以下为原文

  I'm glad to hear the software is working for you. That error usually comes up if you don't change the address from GPIB0 to HPIB7.  That software usually needs to see HPIB7 go to Agilent I/O connection expert and change the SICL interface ID to HPIB7 you can't scroll to it but just type it in  if you run into errors try that. I hope this helps.

Joe Lubecky
Test Equipment Plus