如何让STEVAL-MKI161V1与Unico GUI和STEVAL-MKI109v2配合使用

我有STEVAL-MKI109v2 MEMS评估板和STEVAL-MKI161V1 MEMS传感器，用于评估陀螺仪加速度计。在st.com上的STEVAL-MKI161V1网页上，它显示该板与MKI109V2板兼容，这太棒了......除了！ Unico GUI软件不会将此列为任何设备类型标识符中的受支持设备。我无法通过传感器测量与设备进行快速通信以进行原型设计......


任何遇到同样问题的人？有什么工作吗？



以下为原文




I have the STEVAL-MKI109v2 MEMS evaluation board and an STEVAL-MKI161V1 MEMS sensor for the board to evaluate a gyroscopic accelerometer. On the STEVAL-MKI161V1 web-page on st.com it shows that this board is compatible with the MKI109V2 board, which is fantastic... EXCEPT! The Unico GUI software doesn't list this as a supported device in any of the device type designators. I haven't been able to get a quick communication to the device to prototype with the sensors measurements...


Anyone experiencing the same issue? Any work arounds?