我用基本启动模式为
STM32mp157a-dk1 板构建了 u-boot：
默认配置：
stm32mp15_basic_defconfig
设备树：stm32mp157a-dk1
我在启动 u-boot 时遇到此错误，如果我尝试从/向 OTP 寄存器读取/写入：
stm32mp1_clk_get_id: 未找到 clk id 69
- U-Boot SPL 2020.10-stm32mp-r2 (Aug 14 2022 - 13:41:53 +0100)
- Model: STMicroelectronics STM32MP157A-DK1 Discovery Board
- RAM: DDR3-DDR3L 16bits 533000kHz
- stm32mp1_clk_get_id: clk id 69 not found
- WDT: Started with servicing (32s timeout)
- Trying to boot from MMC1
- U-Boot 2020.10-stm32mp-r2 (Aug 14 2022 - 13:41:53 +0100)
- stm32mp1_clk_get_id: clk id 69 not found
- stm32mp1_clk_get_id: clk id 69 not found
- stm32mp1_clk_get_id: clk id 69 not found
- stm32mp1_clk_get_id: clk id 69 not found
- CPU: STM32MP157C?? Rev.?
- Model: STMicroelectronics STM32MP157A-DK1 Discovery Board
- Board: stm32mp1 in basic mode (st,stm32mp157a-dk1)
- stm32mp1_clk_get_id: clk id 69 not found
- DRAM: 512 MiB
- Clocks:
- - MPU : 650 MHz
- - MCU : 208.878 MHz
- - AXI : 266.500 MHz
- - PER : 24 MHz
- - DDR : 533 MHz
- stm32mp1_clk_get_id: clk id 69 not found
- Can't find stm32mp_bsec driver
- WDT: Started with servicing (32s timeout)
- NAND: 0 MiB
- MMC: STM32 SD/MMC: 0
- Loading Environment from MMC... *** Warning - bad CRC, using default environment
- In: serial
- Out: serial
- Err: serial
- stm32mp1_clk_get_id: clk id 69 not found
- stm32mp1_clk_get_id: clk id 69 not found
- stm32mp1_clk_get_id: clk id 69 not found
- STM32MP> fuse read 0 57
- Reading bank 0:
- Word 0x00000039:stm32mp1_clk_get_id: clk id 69 not found
