Powerint LNK460VG 100W A19 LED灯电源方案

移动通信

308人已加入

描述

关键词: LED , LNK460VG , Powerint , 电源

Powerint公司的DER322参考设计采用LinkSwitch-PL系列LNK460VG器件,是业界首个可替代100W A19白炽灯的LED驱动器,采用单层PCB,具有低成本少元件数和小尺寸特点,230VAC时的效率大于93%,PF大于0.9,230 VAC; 78 V LED时的THD小于20%,集成了包保护和可靠性特性,热关断自动恢复。本文介绍了LinkSwitch-PL系列产品亮点,方框图,典型应用威廉希尔官方网站 以及DER322参考设计主要特性和指标,威廉希尔官方网站 图,材料清单和PCB布局图。

The LinkSwitch-PL family enables a very small and low cost single-stage power factor corrected constant current driver for solid state lighting. Optimized for direct LED current sensing, the LinkSwitch-PL operates over a wide input voltage range delivering an output power of up to 16 W. The LinkSwitch-PL control algorithm provides flicker-free TRIAC dimming with minimal external components.

Each device incorporates a 725 V rated power MOSFET, a novel discontinuous mode variable frequency variable on-time controller, frequency jitter, cycle by cycle current limit and hysteretic thermal shutdown in a monolithic 4-pin IC, available in SO-8C, eSOP-12, and eDIP-12 packages.

LinkSwitch-PL系列产品亮点:

Dramatically Simplifies Off-line LED Drivers

• Flicker-free phase-controlled TRIAC dimming

• Single stage power factor correction and accurate constant current (CC) output

• Very low component count with small non-electrolytic bulk capacitor for compact replacement lamp designs

• Compact SO8, eSOP, and eDIP packages

• Completely eliminates control loop compensation

Advanced Performance Features

• Optimized for non-isolated flyback designs

• Frequency jitter greatly reduces EMI filter size and costs

• Low dissipation direct sensing of LED current

Advanced Protection and Safety Features

• Cycle skipping regulation for abnormally low output power to clamp peak output current delivered

• 725 V integrated power MOSFET allows small bulk capacitance and maximizes power capability

• Short-circuit, overload, open feedback and output overvoltage protection

• Hysteretic thermal shutdown

• Meets high-voltage creepage between DRAIN and all other pins both on PCB and at package

EcoSmart™ - Energy Efficient

• High power factor optimizes system lumen per input VA

• Control algorithm balances switching and conduction losses over line and load to maintain optimum efficiency

2012-3-30 12:45:25 上传

下载附件 (17.04 KB)


图1。LinkSwitch-PL系列功能方框图

2012-3-30 12:45:25 上传

下载附件 (12.43 KB)


图2。LinkSwitch-PL系列典型应用威廉希尔官方网站 图

2012-3-30 12:45:25 上传

下载附件 (21.93 KB)


图3。采用LinkSwitch-PL系列的替代A19白炽灯的5W 15V LED驱动器威廉希尔官方网站 图

DER322参考设计

High Efficiency (>93%), High Power Factor(>0.9), 18 W Output Non-Isolated Buck LED Driver Using LinkSwitchTM-PL LNK460VG

The document describes a non-isolated, high efficiency, high power factor (PF) LED driver designed to drive a nominal LED string voltage of 78 V at 230 mA from an input voltage range of 195 VAC to 265 VAC (47 Hz – 63 Hz). The LED driver utilizes the LNK460VG from the LinkSwitch-PL family of ICs.

The topology used is a single-stage non-isolated buck that meets the stringent space and efficiency requirements for this design. LinkSwitch-PL based designs provide high power factor (>0.9) meeting international requirements.

This document contains the LED driver specification, schematic, PCB details, bill of materials, transformer documentation and typical performance characteristics.

DER322参考设计主要特性:

 Single-stage power factor correction combined with constant current (CC) output

 Low cost, low component count, small size and single-sided PCB

 Highly energy efficient, >93% at 230 VAC input for 78 V LED Load

 Integrated protection and reliability features

 Single shot no-load protection / output short-circuit protected with auto-recovery

 Auto-recovering thermal shutdown with large hysteresis protects both components and PCB

 No damage during brown-out conditions

 PF >0.9 at 230 VAC

 % ATHD <20% at 230 VAC; 78 V LED

 Meets IEC ring wave, differential line surge and EN55015 conducted EMI

2012-3-30 12:45:25 上传

下载附件 (35.16 KB)


2012-3-30 12:45:25 上传

下载附件 (89.65 KB)


图4。DER322参考设计外形图:上:顶视图,下:底视图

DER322参考设计电源指标:

2012-3-30 12:45:25 上传

下载附件 (36.3 KB)


2012-3-30 12:45:25 上传

下载附件 (14.64 KB)


图5。DER322参考设计威廉希尔官方网站 图

DER322参考设计材料清单(BOM):

2012-3-30 12:45:25 上传

下载附件 (59.89 KB)



2012-3-30 12:45:25 上传

下载附件 (35.71 KB)


2012-3-30 12:45:25 上传

下载附件 (66.55 KB)


图6。DER322参考设计PCB布局图(53.5 mm x 19.6 mm):上:顶层;下:底层
详情请见:

linkswitch-pl_family_datasheet[1].pdf (1.75 MB, 下载次数: 5)

2012-3-30 12:41:32 上传

下载次数: 5
下载积分: 积分 -1


der322[1].pdf (4.33 MB, 下载次数: 5)

2012-3-30 12:44:19 上传

下载次数: 5
下载积分: 积分 -1

打开APP阅读更多精彩内容
声明:本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人,不代表电子发烧友网立场。文章及其配图仅供工程师学习之用,如有内容侵权或者其他违规问题,请联系本站处理。 举报投诉
  • 相关推荐

全部0条评论

快来发表一下你的评论吧 !

×
20
完善资料,
赚取积分