我试图通过STVP使用ST-Link在STM8S103F2P6中编写一个hex文件
但是,我收到错误
>编程PROGRAM MEMORY区域......
错误:无法与
威廉希尔官方网站
板
通信。
错误的威廉希尔官方网站
板选择或检查威廉希尔官方网站
板供电或检查前一个会话是否已关闭。
错误:< PROGRAM MEMORY编程失败。
组态:
Windows SP3,
STLINK V1,
固件:V1.J12.S3 JTAG + SWIM调试器
目标:STM8S103F2P6
是否有另一个实用程序可用于通过ST-Link对STM8S进行编程。
谢谢。
#stlink #stm8-swim-connect
以上来自于谷歌翻译
以下为原文
I am trying to program a hex file in STM8S103F2P6 using ST-Link via STVP
However, I get the error
> Programming PROGRAM MEMORY area...
Error : Cannot communicate with the board.
Wrong board selec
tion or check board power supply or check that a previous session is closed.
Error : < PROGRAM MEMORY programming failed.
Configuration:
Windows SP3,
STLINK V1,
Firmware: V1.J12.S3 JTAG+SWIM Debugger
Target: STM8S103F2P6
Is there another utility that can be used to program STM8S via ST-Link.
Thanks.
#stlink #stm8-swim-connect