10MHz参考输出到多个输入怎么做？

您好，我有一个信号发生器，我想将10MHz Ref Out连接到3个不同硬件（2个SpecAns和我的DUT）的3个10MHz参考输入。
我的基本问题是，我该怎么做？
使用阻抗匹配的功率分配器或简单的三通或者这是不推荐的？
我觉得使用分离器可能会导致相位问题，因为它在输入和输出之间有几度的相位差。
关于设置的更多信息：我正在处理一个内置VXI SigGen和SpecAn的测试站。来自SigGen的10MHz Ref已经通过一个简单的T形接口提供SpecAn 10MHz输入并提供对10MHz参考的访问权限
前面板。
我想在前面板上使用该连接将此引用输入到外部辅助SpecAn以及DUT。
我希望通过外部SpecAn避免菊花链接，因为它需要我的接口设备上的额外连接器。
我担心力量不够。
规格如下：SigGen输出> 0dBm，内部SpecAn输入> -3dBm，外部SpecAn输入> 0dBm，DUT> -5dBm。
一次只能使用一个SpecAn;
但是，内部电源将始终通电并连接。
非常感谢任何帮助或建议。
谢谢，J



     以下为原文

  Hello,

I have a signal generator and I would like to connect the 10MHz Ref Out of it to 3 10MHz Ref Inputs of 3 different pieces of hardware (2 SpecAns and the my DUT). My basic question is, how would I do this? Using an impedance matched power splitter or a simple tee or is this just not recommended? I feel using the splitter may cause phase issues since it has a few degree phase difference between input and output.  

A little more about the setup: Im dealing with a test station that has a VXI SigGen and SpecAn built in. The 10MHz Ref from the SigGen already goes through a simple tee to feed the SpecAn 10MHz input and give access to to the 10MHz ref at the front panel. I want to use that connection at the front panel to input this reference to an external auxiliary SpecAn and also to the DUT. I was hoping to avoid daisy chaining through the external SpecAn because it would require an additional connector on my interface device. I'm worried the power will not be sufficient. The specifications are as follows:The SigGen output is >0dBm, the interal SpecAn input is >-3dBm, the external SpecAn input is >0dBm, and the DUT is >-5dBm. Only one SpecAn will be used at a time; however, the internal one will always be powered on and connected.

Any help or advise is greatly appreciated.

Thanks,
J