[问答]

esp32s3 wifi mesh子节点无法获取内网IP是为什么？

问答对人有帮助，内容完整，我也想知道答案 0 目前使用两块esp32s3 模组 ,使用的是ESP IDF 父节点一直报错: 非法子节点 (493102) mesh: 1316[recv]invalid child 68:b6:b3:3c:64:68 I (493102) mesh: 1316[recv]invalid child 68:b6:b3:3c:64:68 [0;32mI (493532) mesh_mqtt: MQTT_EVENT_PUBLISHED, msg_id=62348[0m [0;32mI (493812) mesh_main: Tried to publish layer:1 IP:192.168.137.154[0m [0;32mI (493812) mesh_mqtt: sent publish returned msg_id=1258[0m [0;32mI (493812) mesh_main: Sending routing table to [0] f4:12:fa26:60: sent with err code: 0[0m [0;32mI (493812) mesh_main: Received Routing table [0] f4:12:fa26:60[0m 子节点上电log如下: I (706) wifi:mode : sta (68:b6:b3:3c:64:68) + softAP (68:b6:b3:3c:64:69) W (7056) wifi:adjust channel:1, secondary channel offset:1(40U) I (7066) wifi:Total power save buffer number: 16 [0;32mI (7066) mesh_main: new channel:6, router BSSID:00:00:00:00:00:00[0m W (7096) wifi:adjust channel:6, secondary channel offset:1(40U) I (7096) wifi:Total power save buffer number: 16 [22:29:38.022]收←◆I (7406) mesh: [SCAN][ch:6]AP:6, other(ID:0, RD:0), MAP:1, idle:0, candidate:1, root:1, topMAP:0[c:0,i:0][0e:9a:3c:87:53:52]router found<> I (7406) mesh: 7369[selection]try rssi_threshold:-78, backoff times:0, max:5<-78,-82,-85> I (7416) mesh: [DONE]connect to parent:ESPM_CD2660, channel:6, rssi:-5, f4:12:fa26:61[layer:1, assoc:0], my_vote_num:0/voter_num:0, rc[00:00:00:00:00:00/-120/0] I (7426) mesh: set router bssid:0e:9a:3c:87:53:52 [22:29:38.284]收←◆I (7666) wifi<6,1>, old:<6,1>, ap:<6,1>, sta:<6,1>, prof:6 [22:29:39.279]收←◆I (8656) wifi:state: init -> auth (b0) I (8676) wifi:state: auth -> assoc (0) E (8686) wifi:Association refused temporarily, comeback time 1536 mSec [22:29:40.837]收←◆I (10216) wifi:state: assoc -> assoc (0) I (10236) wifi:state: assoc -> run (10) I (10236) mesh: <><><><><><> I (10236) mesh: from assoc, layer:2, root_addr:f4:12:fa26:61, root_cap:1 I (10236) mesh: idle, layer:2, root_addr:f4:12:fa26:61, conflict_roots.num:0<> I (10246) wifi:connected with ESPM_CD2660, aid = 1, channel 6, 40U, bssid = f4:12:fa26:61 I (10256) wifi:security: WPA2-PSK, phy: bgn, rssi: -5 [0;32mI (10266) mesh_main: root address:f4:12:fa26:61[0m [22:29:40.930]收←◆I (10316) wifi:pm start, type: 0 I (10316) wifi:set rx beacon pti, rx_bcn_pti: 0, bcn_timeout: 0, mt_pti: 25000, mt_time: 10000 I (10316) mesh: [scan]new scanning time:600ms, beacon interval:300ms I (10326) mesh: 2004parent monitor, my layer:2(cap:6)(node), interval:11599ms, retries:1 I (10326) wifi:BcnInt:102400, DTIM:1 [0;32mI (10336) mesh_main: layer:0-->2, parent:f4:12:fa26:61, ID:77:77:77:77:77:76[0m [0;32mI (10346) mesh_netif: It was a wifi station removing stuff[0m [0;32mI (10356) mesh_main: state:0[0m [22:29:52.825]收←◆I (22206) mesh: 5156parent layer:1(node), channel:6, rssi:-5, assoc:0(cnx rssi threshold:-120)my_assoc:0 [22:29:54.330]收←◆I (23716) mesh: 5947parent layer:1, rssi:-6, assoc:0(cnx rssi threshold:-120) I (23716) mesh: [SCAN][ch:6]AP:1, other(ID:0, RD:0), MAP:1, idle:0, candidate:1, root:1, topMAP:0[c:2,i:2][0e:9a:3c:87:53:52] I (23716) mesh: 7369[weak]try rssi_threshold:-120, backoff times:0, max:5<-78,-82,-85> I (23726) mesh: 716[monitor]no change, parent:f4:12:fa26:61, rssi:-6 I (23736) mesh: 2004parent monitor, my layer:2(cap:6)(node), interval:11860ms, retries:2<> [22:30:06.507]收←◆I (35886) mesh: 5156parent layer:1(node), channel:6, rssi:-5, assoc:0(cnx rssi threshold:-120)my_assoc:0 [22:30:08.010]收←◆I (37396) mesh: 5947parent layer:1, rssi:-6, assoc:0(cnx rssi threshold:-120) I (37396) mesh: [SCAN][ch:6]AP:1, other(ID:0, RD:0), MAP:1, idle:0, candidate:1, root:1, topMAP:0[c:2,i:2][0e:9a:3c:87:53:52] I (37396) mesh: 7369[weak]try rssi_threshold:-120, backoff times:0, max:5<-78,-82,-85> I (37406) mesh: 716[monitor]no change, parent:f4:12:fa26:61, rssi:-6 I (37416) mesh: 2004parent monitor, my layer:2(cap:6)(node), interval:4639ms, retries:3<> [22:30:12.792]收←◆I (42176) mesh: 5156parent layer:1(node), channel:6, rssi:-5, assoc:0(cnx rssi threshold:-120)my_assoc:0 [22:30:14.297]收←◆I (43676) mesh: 5947parent layer:1, rssi:-5, assoc:0(cnx rssi threshold:-120) I (43676) mesh: [SCAN][ch:6]AP:1, other(ID:0, RD:0), MAP:1, idle:0, candidate:1, root:1, topMAP:0[c:2,i:2][0e:9a:3c:87:53:52] I (43686) mesh: 7369[weak]try rssi_threshold:-120, backoff times:0, max:5<-78,-82,-85> I (43696) mesh: 716[monitor]no change, parent:f4:12:fa26:61, rssi:-5 I (43706) mesh: 2004parent monitor, my layer:2(cap:6)(node), interval:301531ms, retries:3<> 0
2023-3-6 06:01:01　　评论淘帖0 邀请回答您可以邀请以下用户，快速回答问题 × wang21cj 该类别下有 38 个回答。邀请回答 hgimtk 该类别下有 38 个回答。邀请回答新星之火12138 该类别下有 33 个回答。邀请回答 chm5 该类别下有 32 个回答。邀请回答 zyh34997 该类别下有 32 个回答。邀请回答就好国dd 该类别下有 32 个回答。邀请回答 zaichenxi 该类别下有 31 个回答。邀请回答 heks 该类别下有 31 个回答。邀请回答四川赵赵该类别下有 29 个回答。邀请回答 flowerddd 该类别下有 29 个回答。邀请回答 muwersddg 该类别下有 29 个回答。邀请回答星星公交站该类别下有 28 个回答。邀请回答 vinww特烦恼该类别下有 28 个回答。邀请回答 caosurround 该类别下有 28 个回答。邀请回答 723662364d 该类别下有 27 个回答。邀请回答 overheat 该类别下有 27 个回答。邀请回答 gvjhvbc 该类别下有 27 个回答。邀请回答安德森大该类别下有 27 个回答。邀请回答 xwgc888 该类别下有 27 个回答。邀请回答 h1654155143.8331 该类别下有 27 个回答。邀请回答举报杨秀英相关推荐 • esp32s3 wifi mesh子节点无法获取内网IP怎么解决？ 241 • esp32s3 wifi mesh子节点无法获取内网IP怎么解决？ 281 • esp32s3 mesh子节点无法获取父节点分配的IP如何解决？ 304 • ESP32能够既作为mesh节点又作为wifi节点？ 311 • ESP32-C3 ble_mesh_provisioner怎么扫描和添加子节点？ 206 • mesh网外的wifi设备如何利用mesh访问外网？ 272 • esp32s3进入light_sleep时出现RTCWDT_RTC_RST重启的原因？ 802 • esp32s3进入light_sleep时出现RTCWDT_RTC_RST重启的原因？ 284 • ESP32S3内部外设包括DMA之类的可以直接用ESP32的配置来启用吗？ 557 • 使用“espconn_mesh_get_node_info”获取节点父节点或子节点时，它无法正常工作怎么解决？ 186