FX3 4Mbyte Chunks传输限制为4MB和XP 3MB

4年前，我开发了一个基于您的SLaveFIFISYNC 2位项目的FX3固件项目。只要我把传输分成4MB或更小的块，它就一直工作得很好。如果我这样做，它整天运行。如果我不知道事情是不可靠的。在我开发应用程序时，我被告知W7我需要将传输限制为4MB和XP 3MB。
我们有另一个FX2设计，我们不必把它转换成块。我们只需在主机侧设置一个传输……到58MB！！！！
摆脱4MB块会很好……尤其是从错误恢复的观点来看，但是我确信如果我不设置很多4MB传输，事情会更快。
我下载了你最新的SDK，V1.3.4。你知道这个4MB传输大小限制是否仍然存在，或者我能做些什么来摆脱它？？
谢谢



     以下为原文
  4 years ago I developed an FX3 firmware project which was based on your SlaveFifiSync 2 bit project. It has always worked fine as long as I break up transfers into 4Mb or smaller chunks. If I do this it runs all day. If I don't things are unreliable. At the time I developed the application I was told for W7 I needed to limit transfers to 4MB and for XP 3MB.

We have another FX2 design which we do not have to break transfers up into chunks. We just setup one transfer on the host side for the whole thing...up to 58MB !!!

It would be nice to get rid of the 4MB chunks...especially from an error recovery point of view but I'm sure things would be faster if I'm not setting up many 4MB transfers.

I downloaded your latest SDK, V1.3.4. Do you know if this 4MB transfer size restriction still exists or what I can do to get rid of it ??

Thanks